Tube Tank Top

Tube Tank Top

Check out this page if you are looking for Tube Tank Top

How To Rebuild A Toilet Tank

One of the simplest plumbing jobs you can tackle all by yourself is that of replacing the toilet tank. It will take you two hours to complete the entire task with barely any difficulty.

Here's how to do it:

Step 1: Turn Off the Water

Turn off the water to the toilet tank by turning off the toilet stop or closet stop, which is by the base. Keep turning the handle clockwise until it shuts off.

Step 2: Drain the Tank

Drain the tank by pushing the handle down and holding it until the water goes all the way down. Hold the handle until no more water goes down the hole. There will still be about 1" of water in the tank. Wipe all the water out using a sponge.

Step 3: Disconnect the Tank

Use a small adjustable wrench to disconnect the toilet stop nut. Disconnect the tank from the bowl by removing the bolts found inside the bottom of the tank.

Using a large screwdriver to support the head on the bolt and then turn the nut under the tank with an adjustable wrench until it is possible to remove the entire bolt from the tank. Repeat the process on all the bolts.

Step 4: Install the Douglas Valve

Carefully align the valve assembly. Gently push through the hole and then turn the locking ring hand tight to make a good seal.

Use large pliers to fully tighten the seal.

Guide the assembly through the hole, then put the tank seal into place that's located on the ball cock and hand tighten the locking nut. Use a small pair of slip-joint pliers to get a more secure fit.

Step 5: Install the Ball cock Assembly

There are 21 pieces to install three tank-to-bowl nuts. Start off with the bolt then slide on a seal. Repeat this process for the other bolts.

It's time for the outside seals. Use the same process as before; squeeze all the rubber seals onto the bolts. Once all the inside and outside seals are in place, slide the brass washers on and lock them into place with thinner nuts. Hand tighten; use an adjustable wrench to secure.

Start with the flexible supply line. It has a heavy-duty seal that should be hand tightened, then use slip-joint pliers a quarter turn. Slide the handle through the hole and then tighten the bolt.

Don't forget to take the overfill tube and place it back into the hole. The overfill tube is what fills up the bowl during the flushing cycle.

Step 6: Reinstall the Tank

Position the tank on top of the bowl. Tighten all of the bolts using small slip-joint pliers and make sure the tank doesn't wobble.

Hold the handle all the way down while the water is filling into the bowl. This will reveal if there are any leaks before the bowl is full of water.

If the seal looks good, let off the handle to allow the bowl to fill up completely. Adjust the water level so it's 1/2" below the fill tube.

How to Make Your Own Drain Cleaner

A slow drain is an incredible annoyance, but a commercial drain cleaner can be both toxic and expensive. You can rent a snake, but rather than spend time and money snaking a drain you could make your own drain cleaner with common, inexpensive household ingredients. This how-to guide will lead you through the easy process of making and applying a homemade drain cleaner without resorting to chemicals or expensive rentals. There are two common methods for making drain cleaner, and neither one of them will set you back more than a few dollars.

6 Steps for Cleaning Out a Tub Drain

The first most people know of a clog in the tub drain is when the water is slow to leave the tub or when it simply won't leave at all. At this point, there's no other choice but to clear the clog. At some point, this will happen to everyone as grease, hair and debris build up gradually in the tub drain. You can call a plumber or use chemical drain cleaners from the store, but there are simpler ways to do it yourself to save money. Most use items you'll have in your house and in a few minutes, your tub drain should be clog fr

<input id="gwProxy" type="hidden" /><input id="jsProxy">

About the Author

We are always equipped, on time, and professional. Our mission at the Plumbing Doctor is simple:
"To deliver quality and efficient services at a competitive price" So make a booking with The
Plumbing Doctor today.

http://www.newcastleplumbing.com.au

Thanks for looking at our Tube Tank Top information.

Maternity Clothes clothes, clothing, inspiration, shopping, tube tank top, video